Installation

1. Put Teflon tape and pipe sealant on WaterBonder thread.
   
   
2. Locate the WaterBonder fitting to the outlet side of the circulation pump. Make sure all connections are wrench-tight. The WaterBonder must be installed in the pool piping system so all water in the system passes through it, and the WaterBonder is always filled with pool water that needs to be bonded.
   
   
3. When bonding the WaterBonder fitting, use a properly sized bonding conductor in accordance with the National Electrical Code (NEC) and state and local electrical and plumbing regulations.
   
   

Notes on installation:

The WaterBonder can be used with piping systems compatible with marine-grade 304 or 316 stainless steel fittings, and comes with stud, nuts, and washer for securing an electrical lug. The electrical lug can be use to bond up to a No. 6 AWG solid conductor.